ZIRO High Speed PLA Filament 1.75mm, Yellow

This was literally steaming coming out of the nozzle, and printed like crap. Dried it for 12 hours and it's fine. Not a huge deal, but I needed yellow specifically for my kids robotics team, and they were on a deadline, so having to dry it first really made the schedule tight. If you always dry your spools before printing, then you might not notice.

This stuff is great! This is my first time trying out a high speed PLA since I built my Voron V0 and this stuff prints very well at some high speeds! I tested it out on a "speedboat" I sliced. I am still tuning my high speed testing, but I set everything to 350mm/s with 10k accel and just sent it. Boat took just a hair under 26mins and looked really good! I was out running my cooling, so some defects and a bit more stringing than normal but not the fault of the PLA

I am for sure going to keep a spool or two of this around when I need to print faster than I normally need to.

Great stuff!